Thanks for downloading!
We'd love to hear from you if the print was successful.
Ipad 2 stand
Stand designed for ipad 2, though I think it will work with newer versions and mini versions
Gadget
Creative Commons Attribution Share Alike
Commercial use is allowed, you must attribute the creator, you may remix this work and the remixed work should be made available under this license.
Attribution
Relatively popular compared to my other prints
Description
As it says above
Materials and methods
Print with plenty of fan for the overhang.
I use 100% after layer 1
PLA works fine
Don't print too quickly
Use layer time limit for the top layers to slow these down.
Layer thickness I would suggest as 0.1 or possibly 0.2 with a 0.4 or 0.6 mm nozzle.
To eliminate any warp, I pause the print about 1 mm height and run a bead of diluted pva glue round the perimeter. Even without warping is not bad.
That aside printing is pretty straight forwad
Edit in 3dslashIssues
Issues are used to track todos, bugs or requests. To get started, you could create an issue.
Comments
Jeremy Pearce published this design ago