<p>This is meant for use with the iPhone 6 Plus with the 1mm hard silicone case. It can be used without the case as shown in the picture, but it is a bit loose. It may work for the iPhone 6S Plus without a case since it is a little larger, but we haven't been able to test this.</p><p>Download iPhone_Watch_Stand.stl for the full, fused file. Send to a service like Shapeways for slick one-piece, support-free printing as shown in the images.<br></p><p>For printing on your own plastic extrusion printer, download Part 1 and Part 2.</p><ul><li>Part 1 can be printed without supports in its current orientation.</li><li>Part 2 should be printed with supports in its current orientation. Support should be minimal and any rough points would be on the back of the stand.</li></ul><p>It is also possible to print as one piece with supports, but you will need to remove support material from under the watch dock.<br></p><p>After printing, glue the two halves together to form a single piece with a small seam in front.</p><p>Original Source Files:<br><a rel="nofollow" target="_blank" href="http://www.thingiverse.com/thing:638001">http://www.thingiverse.com/thing:638001</a><br><a rel="nofollow" target="_blank" href="http://www.thingiverse.com/thing:814577">http://www.thingiverse.com/thing:814577</a></p>
Creative Commons Attribution Share Alike
