Thanks for downloading!
We'd love to hear from you if the print was successful.
iPhone Cradle for the Vauxhall Vivaro (2014-2019)
Mount your iPhone onto your dashboard.Gadget
Creative Commons Attribution Noncommercial No Derivatives
Commercial use is not allowed nor can you remix or change this work & you have to attribute the creator.
This is a two piece design for the 2014-2019 version of the Vivaro van. It fits into the top section of the centre of the dashboard and will hold an iPhone 6 that is fitted with Spigen (Tough Armor) case.
The phone will fit without the case but it is a bit sloppy. Internal dimensions of the cradle are 75mm x 12mm.
There is a slot at the base so that a charger cable can be easily inserted into the phone. The holder is extremely sturdy and using the screen does not cause any wobble.
Printed in PETG at 0.26mm layer height. The two parts are fixed together with a self tapping screw and a washer - see photo. This allows the cradle to swivel on the base. The tilt angle is fixed and cannot be adjusted.
Materials and methods
Printer: Ender 3
Resolution: 0.26 mm
Nozzle Temp: 240°
Bed Temp: 70°
Top Layers: 4
Bottom Layers: 3
On the cradle I used a 5mm brim and supports on the print bed only.
The base needed a minimal amount of supports on the print bed only.
Screenshots of the orientation of the sliced files can be seen on the photos section.
Issues are used to track todos, bugs or requests. To get started, you could create an issue.