This is a two piece design for the 2014-2019 version of the Vivaro van. It fits into the top section of the centre of the dashboard and will hold an iPhone 6 that is fitted with Spigen (Tough Armor) case.
The phone will fit without the case but it is a bit sloppy. Internal dimensions of the cradle are 75mm x 12mm.
There is a slot at the base so that a charger cable can be easily inserted into the phone. The holder is extremely sturdy and using the screen does not cause any wobble.
Printed in PETG at 0.26mm layer height. The two parts are fixed together with a self tapping screw and a washer - see photo. This allows the cradle to swivel on the base. The tilt angle is fixed and cannot be adjusted.
Creative Commons Attribution Noncommercial No Derivatives