×Read this message from Erik, founder of YouMagine

"Lazy Susan" Rotating printer stand

My UM2 is mounted on top of a rotating base giving all round access

3D printer parts and enhancements

Creative Commons Attribution Share Alike

Commercial use is allowed, you must attribute the creator, you may remix this work and the remixed work should be made available under this license.

Learn more or download attribution tags


This is a rotating mounting platform for my Ultimaker2,

Enables all round access to the printer with out having to pick it up or reach over the top etc. makes filament changes a doddle.

The bottom board is longer than the top board so that if its pushed back against the wall it still has enough clearance to rotate.

The hole in the center for the cables helps prevent twisting the cables as you rotate the printer to access the other sides.

Materials and methods

12" Round Lazy Susan Bearing (approx £13)
screws to mount bearing
Wooden Board (DIY store)
rubber feet. (DIY store)
Hole Cutter and insert (Ikea)



    Issues are used to track todos, bugs or requests. To get started, you could create an issue.


    Mini imageIzzy commented ago

    The top platform is 400mm x 400mm

    The base board is 500mm x 500mm

    Cut from a single board 900x400 x 18mm thick.

    Which works fine for the dimensions of both the UM2 and Wanhao Dublicator i3 Plus.

    The lazy Susan has rubber feet underneath to allow for the cables, protect the table and dampen vibrations.

    But I will try some sorbothane to see if there is a difference.

    0657d6529c54c3bdd0ee0abe1f75010c?default=blank&size=40Ryan Shuck commented ago

    Using sorbothane vibration dampers underneath would do well to reduce noise. What are the dimensions of the platform pieces?

    Mini dsc 0153Casey added this to the Ultimaker Accessories collection ago
    Mini imageIzzy published this design ago