Thanks for downloading!
We'd love to hear from you if the print was successful.
LC-Display-Housing for Reprap-Display
A Housing for RepRap LC-Display (Prusa, CTC, Geeetech)
3D printer parts and enhancements
Creative Commons Attribution Share Alike
Commercial use is allowed, you must attribute the creator, you may remix this work and the remixed work should be made available under this license.
Description
The cheap prusa-clones all have a LC-display on top of them, with a knob for navigation. To get the display on front of the printer, you need a housing that has also a hole to plug in your SD-cards.
The housing is slit into three parts, two parts to print the holes without need for support, and a back closing.
Materials and methods
I used PLA to print this, on a cheap prusa
Documents
Edit in 3dslash
Issues
Issues are used to track todos, bugs or requests. To get started, you could create an issue.
Comments
printinator commented agoSimply enter "CTC" into the search bar
or go to https://www.youmagine.com/designs/reprap-display-housing-mach-2
Minihawk commented agoI don't mind at all, give a link where to find it ...
printinator commented agohi Minihawk i hope you don´t mind that i upgraded your design
Jake Smith added this to the Printrbot collection agoMinihawk printed this ago
- Printed on:
- prusa i3
- Result:
- Looks good, but the first layer is a bit bigger, giving a sharp edge, perhaps should be sanded or cutted away. Its also at the arrea the two parts are glued together.
- Feedback:
- I am the designer :)
Minihawk published this design ago