A long while back Leah asked me to design and print her a vase that would look good even if it didn't have flowers in. After some nagging I eventually got around to it. Glad I did as it's been a fun project.

• VASE
• flower vase
• art
• rose vase

Creative Commons Attribution Noncommercial Share Alike

Commercial use is not allowed, you must attribute the creator, you may remix this work and the remixed work should be made available under this license.

Learn more or download attribution tags

Description

Materials and methods

Update : 03/01/2016

I've added a 3D printed mold pattern for sand casting a lead weight to fir in the bottom of the water tube.

Also the water tube will require sealing with PVA or epoxy.

--------------------------------------------------

The vase is designed to be printed without supports.

The vase in the video was printed in PLA , with 0.15mm layer heights.

To use the water tube, fill with water and then lower the vase over it... add follower :-)

With some flowers the vase is a bit top heavy. If so add some weight to the base of the tube.

Documents

Comments

Leave a comment

Log in to leave a commentDon’t have an account yet? Sign up here!

LkWatts added this to the Gifts collection almost 2 years ago

oaevjen added this to the nice collection about 6 years ago

Charo Sanchez added this to the casa collection almost 7 years ago

Vernon Barry printed this about 7 years ago

Printed on:

Ultimaker - Ultimaker Original

Result:

Raise 3D N2 using their PLA and the default Ideamaker N2 "Speed" profile. ).2mm layer height, 2 shells, total time is 21 hours.

Feedback:

Thanks for such a wonderful design!!!

Steve_J published this design over 7 years ago