Lezyne Pump pin wrench

This is a pin wrench to disassemble and repair a Lezyne bicycle pump

Commercial use is allowed, you must attribute the creator, you may remix this work and the remixed work should be made available under this license.

This is a 3D printable Spanner Wrench to allow easy replacement of worn seals on most, but not all, Lezyne pumps. Print this part, and install two 12.5 gauge finish nails.
Home Depot:
https://www.homedepot.com/p/Grip-Rite-12-1-2-x-2-1-2-in-8-Penny-Bright-Steel-Nails-1-lb-Pack-8F1/202308477
Lowes:
https://www.lowes.com/pd/Fas-n-Tite-1-lb-12-5-Gauge-2-5-in-Hot-Dipped-Galvanized-Finish-Nail/1000098208
Heat the nails with a soldering iron to get the heads flush. Trim the protruding part of the nails to about 1/4" (≈6mm), and the tool is ready to use.

Issues are used to track todos, bugs or requests. To get started, you could create an issue.

Air Rocket Works, LLC published this design almost 6 years ago