Magnetic Circle Fidget
===
This is a simple magnetic fidget to help you fight your long work calls.
Blue: magnets attracting
Red: magnets repelling
# Materials
10x [Neodymium 6mm x 2mm magnets](https://amzn.to/3dbej1S)
1x [608ZZ ball bearing](https://amzn.to/3jK2WiT)
<small>Product links contain my referral, please search for the product name if you prefer not to use them</small>
# Print
Print as shown in the picture below without any support. Brim as needed by your printer.
Recommended settings for printing are 0.1mm layer height and 5% gyroid infill but I think 0.2 layers would work too.
# Assembly
Simply print as shown in the pictures, and push 1x [608zz bearing](https://amzn.to/3jK2WiT) in the middle of the ring.
Insert 10x [6mm x 2mm magnets](https://amzn.to/3dbej1S) in the slots (both in the ring and the arm) and then clip the two arm pieces together.
Depending on your printer tolerances, everything should snap in place without the need of any glue but have some superglue ready at hand just in case.
# Donations ⭐
[](https://ko-fi.com/C0C43KO15)
https://ko-fi.com/clait
###### tags: `fidget` `desk toy` `magnet` `magnetic` `magnetic fidget` `magnetic toy`
Creative Commons Attribution Noncommercial Share Alike
