Thanks for downloading!
We'd love to hear from you if the print was successful.
Makibox D8 - USB repair guide
Your USB port is damaged ? Don't worry, you can repair it !3D printer parts and enhancements
Creative Commons Attribution Share Alike
Commercial use is allowed, you must attribute the creator, you may remix this work and the remixed work should be made available under this license.
I show you where you can solder a new USB port if the tracks on the board are damaged. Your Makibox D8 board will never die !
When everything is soldered, you can apply some hot glue on the new wire on the board to prevent pulling, but I don't recommend to apply hot glue directly on soldering point because if you have to solder again, it will be harder...
You can also solder this points differently :
• WHITE on the R2 component (on the empty side, not on the chipset side)
• GREEN on the R3 component (on the empty side, not on the chipset side)
Issues are used to track todos, bugs or requests. To get started, you could create an issue.