<p>This is a simple bottle opener that can attach to a key ring. This is the shooting pose from the Megaman sprite sheet, with extra material added to grip the bottle cap.<br><br>Note: I recommend a fill density of 50% or higher. My first print broke with a fill density of 19.</p><p>I printed this with a printrbot play, .4mm nozzle, grey PLA at 208 degrees. Used painters tape and TRESsemme extra hold which kept it solid to the plate. I printed this upright with supports, as the detail is the same on both sides and is subtle enough that I didnt want to scrape the brim off of one side.</p><p>Here is my first attempt opening a beer bottle with it, and it FAILS - 19% is way too little infill. I will be updating the design shortly to also add some extra support<br></p><p><a href="https://youtu.be/Sg94Thkk4xg" target="_blank" rel="nofollow">https://youtu.be/Sg94Thkk4xg</a></p>
Creative Commons Attribution Share Alike
