This is a replica of Thor's hammer made into a drawer handle. The basic geometry was made in Freecad (See .FCSTD files below) and exported as STL files. Using the images below, with Inkscape and openscad, STL files were also created of each image. Blender and its boolean functions were then used to combine all of the STL files into a single STL file.
The hammer is designed to fit hex-head bolts into the side so that they can be glued and put through the drawer.
Based on the designs seen below:
https://www.pinterest.com/pin/418482990350645883/
http://www.clipartbest.com/celtic-knot-page-border
http://www.michaelsharp.org/the-dove-logo/
Creative Commons Attribution Share Alike
