Thanks for downloading!
We'd love to hear from you if the print was successful.
Modular NAS for Raspberry Pi or NanoPi M4V2 with 2.5in Drives
A printable frame to build a NAS using a Raspberry Pi or a NanoPiGadget
Creative Commons Attribution Share Alike
Commercial use is allowed, you must attribute the creator, you may remix this work and the remixed work should be made available under this license.
This is a frame to make a NAS out of a Raspberry Pi 4 or a NanoPi M4 and some 2.5 inch laptop drives (files for 3.5" also included. You can use SSD or HDD. The design is modular so you can stack as many drives as you want. You will need:
Raspberry Pi Amazon shopping cart:
Nano Pi BOM
Nano Pi Amazon shopping cart:
(1) Either the Raspberry Pi mount or the NanoPi mount.
(2) Clips for each drive. If you have 4 drives, print 8 clips
(2) Risers (NanoPi or Raspberry Pi)
(2) Left Sides
(1) Fan mount (for Raspberry Pi only)
Assemble the drive clips on to each drive. Slide them on from the bottom and put the protrusions on the clip into the screw holes on the drive
Clip the Raspberry Pi into place. Make sure the indentation in the printed piece corresponds to the position of the SD card on the Pi.
Plug the fan into pins 2 (positive) and 5 (negative) of the Pi.
If using the NanoPi, note the direction, the USB ports should face the side marked BACK.
Issues are used to track todos, bugs or requests. To get started, you could create an issue.