<p>Mostly Printed CNC / MultiTool</p>
All the current parts can be found at <a rel="nofollow" target="_blank" href="https://www.vicious1.com/">vicious1.com</a>
<p>Nice write up, explains this in more detail <a rel="nofollow" target="_blank" href="http://www.3ders.org/articles/20150728-ryan-zellars-shares-designs-for-impressive-mostly-3d-printed-reprap-cnc-machine.html">http://www.3ders.org/articles/20150728-ryan-zellars-shares-designs-for-impressive-mostly-3d-printed-...</a></p><p>I set out to build a minimal cost CNC Machine with the goal of some basic aluminum capabilities. Not a speed demon but it gets the job done. I am very happy with its capabilities.</p><p>Wood Demo<br><a rel="nofollow" target="_blank" href="https://youtu.be/c8_lJPNWDwA">https://youtu.be/c8_lJPNWDwA</a></p><p>3D Printing<br><a rel="nofollow" target="_blank" href="https://youtu.be/amo8czFC75Y">https://youtu.be/amo8czFC75Y</a></p><p>Dual head<br><a rel="nofollow" target="_blank" href="https://youtu.be/TZso__iMGu8">https://youtu.be/TZso__iMGu8</a></p><p>Test<br></p><p><a rel="nofollow" target="_blank" href="http://youtu.be/H_HT3gl6_RI">http://youtu.be/H_HT3gl6_RI</a></p><p>Hope this helps<br><a rel="nofollow" target="_blank" href="http://www.vicious1.com/">http://www.vicious1.com/</a><br>Hardware and printed parts available here.<br><a rel="nofollow" target="_blank" href="http://www.vicious1.com/store/">http://www.vicious1.com/store/</a></p><p>Printing info<br><a rel="nofollow" target="_blank" href="http://www.vicious1.com/blog/parts/">http://www.vicious1.com/blog/parts/</a></p><p>The only special tools needed are a hacksaw, and a drill to drill 4 holes.</p><p>This can be easily expanded to almost any length, width, and depth depending on rigidity required. Shorter lengths = more rigid.</p><p>Most woods and plastics should be no problem. I test milled Aluminum with a footprint of 23.5in x 32in x 4in. Aluminum works well, I have a lot to learn but did a test cut of 6061 with a 1/8" 2 flute endmill at 15k RPM, .005" step down, 15in/min feed rate. These feeds and speeds seemed conservative.<br>Rough- <a rel="nofollow" target="_blank" href="https://youtu.be/hbdGyGBq8K8">https://youtu.be/hbdGyGBq8K8</a></p>
Creative Commons Attribution Noncommercial Share Alike
