Thanks for downloading!
We'd love to hear from you if the print was successful.
MULTI CHARGE REGULATOR HOUSING
HOUSING FOR REGULATOR XH-M602
Maker/DIY
Creative Commons Attribution Noncommercial Share Alike
Commercial use is not allowed, you must attribute the creator, you may remix this work and the remixed work should be made available under this license.
Description
REGULATOR CASING
I PURCHASED THE CHARGE CONTROL CIRCUIT BOARD ON BOB SA - XH-M602 TO CHARGE THE LI-ION BATTERIES OF MY E-BIKE AND NEEDED A HOUSING FOR THE ELECTRICAL BOARD SO I SAT DOWN AND PUT IT TOGETHER WITH TINKERCAD - MY CALIPER VERNIER, RULER AND THE CIRCUIT BOARD IN HAND BUILT A DUMMY CIRCUIT BOARD TO CHECK INSIDE MEASUREMENTS OF MOUNTINGS IN THE CASE AND TO AID VENTILATION , THE REAR VENTILATED BACK BOARD SLIDES INTO POSITION AFTER THE BOARD HAS BEEN MOUNTED AND THE POWER SWITCH AND CONNECTOR SOCKETS HAS BEEN FITTED -AND 26 HOURS LATER - VOILA ......PRINTING
CIRCUIT BOARD,ELECTRICAL CIRCUIT,BATTERY CHARGER REGULATOR, LI-ION BATTERY, E BIKE,SPECS ON CIRCUIT BOARD = Battery Charger 18650 Li-ion (6-120V) Charger Controller Board XH-M602
Input Voltage: 220V AC
Charging Type: 6 - 120V Storage Battery Charger (Lead acid, Nimh, Nicd, Li-ion)
Size: 86 x 58 x 24mm
NEED MINIMAL SUPPORT - JUST PUT DOWN A SKIRT, PRINTED AT 210 DEG CELSIUS NOZZLE - 50 DEG CELCIUS BED HEAT, PRINT SPEED 120 % TOOK ABOUT 20 HRS WITH PLA
Materials and methods
NEED MINIMAL SUPPORT - JUST PUT DOWN A SKIRT, PRINTED AT 210 DEG CELSIUS NOZZLE - 50 DEG CELCIUS BED HEAT, PRINT SPEED 120 % TOOK ABOUT 20 HRS WITH PLA
Documents
Edit in 3dslashIssues
Issues are used to track todos, bugs or requests. To get started, you could create an issue.
Comments
Dan published this design ago