Thanks for downloading!
We'd love to hear from you if the print was successful.
Obstacle Avoiding Robot
DIY! Obstacle Avoiding RobotMaker/DIY
Creative Commons Attribution Share Alike
Commercial use is allowed, you must attribute the creator, you may remix this work and the remixed work should be made available under this license.
This 3D printed robot is controlled by arduino, programmed to avoid obstacle using an ultrasonic sensor
Arduino #Robot #ultrasonicsensor
List of parts:
Servo MG90S - http://s.click.aliexpress.com/e/_dSTUmGQ
L298 mini Driver - http://s.click.aliexpress.com/e/_dUH6YTj
Arduino Nano - http://s.click.aliexpress.com/e/_d7EFcFd
Ultrasonic sensor - http://s.click.aliexpress.com/e/_dYUXR5d
Battery – NiCd 4.8V
Wheels – http://s.click.aliexpress.com/e/_dVuzQCn
Motor – 100 RPM @ 6 Volts - http://s.click.aliexpress.com/e/_dVS6Jil
LEDs - 5 mm -Red, Green & Yellow
3x resistor 1K
You can try different bolt sizes
For Arduino codes, MP3 files and much more, please support me on Patreon: http://www.patreon.com/HendrikxWorkshop
Thanks, Enjoy it!
Issues are used to track todos, bugs or requests. To get started, you could create an issue.