Issue Low quality output #2

Magnolia Titanium opened this issue on April 14, 2020 22:48

Unfortunately, the 3DVerkstan model presents many pitfalls on the elbows and even with high quality of PETG I found that the stringing on the legs, basically the legs don't adhere properly unless there is infill. Last week I printed over 100 units from 3DVerkstan model, only 38 survived our quality assurance tests. Most snapped by the join of the legs and headband. That using high quality PETG and the settings provided by 3DVerkstan, I even added 30% infil which made the model stronger and slowed the pace to 15mm/s. That is why I decided to move to a different model. All files will stay remain but would be labeled as deprecated.

    Comments

    There are no comments yet.

    Back to Open Source Protective Visor by MagnoliaTitanium