OpenRC Calibration Cube

Creative Commons Attribution Share Alike

Commercial use is allowed, you must attribute the creator, you may remix this work and the remixed work should be made available under this license.

Before you start printing the OpenRC F1 that uses pockets to fit the small M3 nuts and see if you need to calibrate your printer for them to fit.

Even if this comes out good, make sure you test the m3 nuts in the first 3dprinted part aswell to be sure.

Issues are used to track todos, bugs or requests. To get started, you could create an issue.

Fraudrin68 added this to the Toys collection about 2 years ago

ramy El Garawany added this to the calibration collection over 2 years ago

ramy El Garawany added this to the RC collection over 2 years ago

Palmettoflyer added this to the RC Cars collection over 3 years ago

Jari added this to the AUTOS, SCHIFFE, FLIEGER, ETC collection over 4 years ago

Jari added this to the 3D DRUCKER + ZUBEHÖR collection over 4 years ago

Daniel Norée published this design over 5 years ago