Lots of parts to this one but the end result was worth it
To facilitate service to my in ground pool I modified RPi OS to open the control page
of my web enable pool interface (AquaLink). This is the enclosure I drew to mount
the RPi to the wall near the pool.
This is a design to create a waterproof wall enclosure to hold a Raspberry Pi
Touch Screen (Seedstudio 7 inch Touchscreen Display) and the raspberry Pi with a
power supply. It all fit in a three duplex wide old work type wall box.
All parts were printed in ABS to allow solvent cementing the fasteners and edges
holes were drilled and small screws fastened the 6 fastener pieces to the 4 glued
screen positioning plates.
Sealing was done using Permatex Ultra Gray gasket sealer around the wall to cover
interface, screen to bezel interface and bezel to back joints.
My Ultimaker 2 printer bed is not large enough for the Back and Bezel so I had
to cut those in two parts to successfully print.