Overhang Test

An overhang test to test the overhang capabilities of your 3D printer

Other

Creative Commons Attribution Share Alike

Commercial use is allowed, you must attribute the creator, you may remix this work and the remixed work should be made available under this license.

Learn more or download attribution tags

Description

I was keen to test the overhang capabilities of my new Artillery Sidewinder X1 3D printer so I created this specific overhang test.

The first upright is 0 deg, the second 10 degrees, the third 20 degrees etc, until we get right to the end in which case the level of overhang is 120 deg, so essentially facing downwards.

Overall, I am very impressed with the result and the level of overhang that the Sidewinder X1 3D printer can print certainly exceeded my expectations. And, whilst not perfect, especially in relation to the 'stringy' and slightly untidy result, I think with tweaked temperature and print speed settings the results can be even better. All in all though, it is the overhang I was testing here and I felt that was very successful.

I hope this test helps others.

Materials and methods

ICE Filaments 'Precious Pink' PLA

Using Ultimaker Cura these were the settings used for the final print:

71.7 x 14.0 x 18.2 mm Size
1 hour 1 minute print time
2 g in weight
0.66 m in filament length used
Super quality 0.12mm
20% infill
200 deg C printing temperature
50 deg C bed temperature
50 mm/s print speed
Enable cooling
Skirt adhesion

Documents

Issues

Issues are used to track todos, bugs or requests. To get started, you could create an issue.

Comments

Mini 3dmodRob @ 3DModUK published this design ago