We are preparing your download, please wait.
PhantomX Turret Accessory Rail
Add a picatinny rail to the PhantomX Turret from Trossen Robotics
Other
Creative Commons Attribution Noncommercial Share Alike
Commercial use is not allowed, you must attribute the creator, you may remix this work and the remixed work should be made available under this license.
Description
A Picatinny (/Weaver) rail for mounting accessories on the Trossen Robotics PhantomX Turret. I used mine to mount a laser sight in a repeatable position. You could also mount two of these side by side.
Note that there is a large bridge area underneath which goes over the screws on the platform. I didn't need to use support material but you might want to.
Materials and methods
4x M2 x 8 screws + washers + nuts
Edit in 3dslashIssues
Issues are used to track todos, bugs or requests. To get started, you could create an issue.
Comments
Printbird commented ago(Don't forget to rotate it to be flat on your print bed, I forgot to do this)
Printbird printed this ago
- Printed on:
- PrintrBot - PrintrBot Plus 2.1
- Result:
- Printed with 0.4mm layers in ABS.
- Feedback:
- Large bridge over the middle could use support, but printed OK without them.
Printbird printed this ago
- Printed on:
- PrintrBot - PrintrBot Plus 2.1
- Result:
- Printed 0.4mm layers in ABS.
- Feedback:
- Large bridge over the center area, might want to add supports.
Printbird published this design ago