Thanks for downloading!
We'd love to hear from you if the print was successful.
Phone holder for use while charging over USBFor your home
Creative Commons Attribution Share Alike
Commercial use is allowed, you must attribute the creator, you may remix this work and the remixed work should be made available under this license.
A phone holder for the desk or table top which can be used in portrait or landscape.
It should fit some tablets as well.
Materials and methods
This can be printed in PLA without supports if your printer is setup well and is capable of bridging.
If you examine the photograph closely you will note that the horizontal bar at the top has is not perfectly horizontal but bows slightly. If you use supports then your print will not bow.
I printed the example in the photograph using Simplify-3D. 0.6mm nozzle, 0.3 mm layer height in PLA on an Ultimaker 2+.
Issues are used to track todos, bugs or requests. To get started, you could create an issue.