Thanks for downloading!
We'd love to hear from you if the print was successful.
Pipe Clamp Phone Holder
Pipe Clamp Phone HolderGadget
Creative Commons Attribution Noncommercial Share Alike
Commercial use is not allowed, you must attribute the creator, you may remix this work and the remixed work should be made available under this license.
I designed this phone holder so I could mount it to my monitor arm. The diameter of the pipe the holder mounts to, is 32mm. For the dimensions of the phone holder itself, look at the final image, which is a technical drawing with the most important dimensions.
The phone holder is printed in 4 parts, though you will need some extra hardware to put it together. In front of the technical drawing is an image that shows what specific hardware is required.
If you want to use the same hardware I used, then you can order the nuts and bolts from the following link (affiliate): https://bit.ly/2VBpAAh
If you want to support me for the designs I publish for free, please consider using my AliExpress Affiliate Link (https://bit.ly/2XYWpHW) when buying something from AliExpress. It doesn't cost you anything extra, but helps me out a lot :)
Materials and methods
You might want to take a look at the orientation of the midpiece, because too much support material can end up causing the print to look quite rough. The same goes for the phone holder part itself. If you add too much support material here, the side flaps holding the phone in place, might brake off when trying to remove the support material.
Issues are used to track todos, bugs or requests. To get started, you could create an issue.