Thanks for downloading!
We'd love to hear from you if the print was successful.
PLA / PVA Little Red Wagon
The Little Red Wagon printed 100% fully assembled.
Toys
Creative Commons Attribution Noncommercial Share Alike
Commercial use is not allowed, you must attribute the creator, you may remix this work and the remixed work should be made available under this license.
Attribution
Description
Having a lot of desktop cleanup to perform, I decided I needed yet another Little Red Wagon (see https://www.youmagine.com/designs/little-red-wagon) yet I didn't have time to assemble one, so I designed the PLA / PVA Little Red Wagon, a remix of the original Little Red Wagon, which is printed 100% fully assembled.
Designed using Fusion 360, sliced using Cura, and printed in PLA and PVA on an Ultimaker 3 Extended.
Materials and methods
Printed in PLA and PVA on an Ultimaker 3 Extended at .1mm vertical resolution and 50% infill
I loaded "PLA_PVA Wagon Upright.stl" model into Cura 2.3.1, then in the Cura 2.3.1 "Preferences, General" pane, I turned off "Automatically drop models to the build plate", then lifted the model 1mm vertical and printed the result. Lifting the model allows Cura to print a bed of PVA to support the wheels which avoids flat spots where the wheels would otherwise come in contact with the build plate.
Place the finished print in a water bath. I use a printed circuit board etching tank with clean water, a heater and an agitator. The PVA dissolved and I had a functional fully assembled Little Red Wagon in just over 2 hours.
Documents
Issues
Issues are used to track todos, bugs or requests. To get started, you could create an issue.