Thanks for downloading!
We'd love to hear from you if the print was successful. If you like the design, please consider donating to the designer.Donate to Cleven
Pocket Ratchet Wrench
Tighten, Flip, Loosen ! ! ! ! Is that a ratchet in your pocket or are you just happy to see me?Gadget
Creative Commons Attribution Noncommercial Share Alike
Commercial use is not allowed, you must attribute the creator, you may remix this work and the remixed work should be made available under this license.
Simple small 3/8in pocket ratchet set, flip from side to side for loosening and tightening. Included 5mm to 13mm sockets.
Use Part 2 and part 3 for internals, V2 of them can be troublesome.
Results may vary on printing. Higher quality is better! :)
Printed at 215-230C 40-50mm/s at 0,1mm. Retraction Enabled.
Issues are used to track todos, bugs or requests. To get started, you could create an issue.
- Printed on:
- Prusa i3 Original Plus
- Print did go well, but the connector broke on trying to click the parts together.
- Please add a note that PLA doesn't work for the pin or make a dedicated PLA pin.
I've printed in pla , abs and nylon. nylon was a bit too flexible. Abs was neutral. I found pla to be the best for me.
PLA or ABS?
i'll be printing a set for a refreshing nonconductive tool.