<p>trying to solve the tensioner problem for e-nable hands and arms.</p><p><br></p><p>This is designed for 0.5mm Spectra 70LB fishing wire</p><p>Printed in PLA so far at 0.15mm layer heights and on the cold end for the filament.</p><p>The idea is that you tie a knot in the cable and slot onto the cog/winder. Cut off the spare. </p><p>Slide in the cog keep slider so that the back is against the back curve of the block.</p><p>Slot in the cog/winder and the cable through the slot to freely wind the cable as much as you want (I do this by hand/small screw driver)</p><p><br></p><p>Push forward the slider to have the tooth in a slot on the clog and you should hear a 'click' as it grips.</p><p>I have made it tight - it does work with some force, but loosens over time and depending on how squished your first layer was.</p><p><br></p><p>Feedback welcome - am about to assemble onto a hand and test in the 'wild'.</p>
Creative Commons Attribution Share Alike