Thanks for downloading!
We'd love to hear from you if the print was successful.
Radiation / Weather shield for Netatmo outdoor sensor
I ordered a Netatmo weather station and want to have a protective mount for the outdoor sensor as it's not really waterproof and also has to be protected from sun radiation to ensure exact measurements. This is a radiation and weather shield to mount the sensor inside.Maker/DIY
Creative Commons Attribution Noncommercial Share Alike
Commercial use is not allowed, you must attribute the creator, you may remix this work and the remixed work should be made available under this license.
Works like a charm! Measurements seem to be accurate, I'll keep an eye on them...
Materials and methods
You will need one of the top.stl, one arm.stl and 6 body.stls. The body is intended to be glued together and should have a nice fit on the mounting arm. In the arm, you can insert an M3 nut and screw to hang the Netatmo sensor.
I printed the top and body parts upside down with support (the body parts with brim) and 100% infill because of the small studs for mounting them together. The arm was printed with 60% infill to make it sturdy enough. The body parts were glued together with UV-curing adhesive (superglue or similar will also work) and the body was put on after the whole thing was mounted to the wall with two 4mm screws.
Issues are used to track todos, bugs or requests. To get started, you could create an issue.