Thanks for downloading!
We'd love to hear from you if the print was successful.
Rake for parts that have fallen under the table
for all who sit at a table and work with small partsMaker/DIY
Creative Commons Attribution Share Alike
Commercial use is allowed, you must attribute the creator, you may remix this work and the remixed work should be made available under this license.
Screws, nuts, electronic parts tend to fall down and roll under the worktable. With this rake you can get them out from under the table again.
Use a round wooden rod or an aluminum tube with 10mm outer diameter for the stem. There are three mounting holes with 3mm diameter
Width is 147 mm, the angle between the stem and the floor is 35°.
Materials and methods
PLA, PET or whatever you like. Easy to print. No supports required.
Design by DesignSpark Mechanical
Issues are used to track todos, bugs or requests. To get started, you could create an issue.