Raspberry Pi 4 Case
Includes two models. One includes an extension to the model with a 4mm hole that can be used for a single screw to mount the model to the wall. This is specifically for the Raspberry Pi 4, and will NOT work on Raspberry Pi 3 or previous versions. Movement of components will prevent the previous versions from fitting.
Raspberry Pi 3 Version: https://www.youmagine.com/designs/raspberry-pi-3-3-case-v2-no-supports-non-mount-version
I designed this to be simple yet fully functional, including:
-Printing in one piece
-Require no supports
-Wall mountable (if need be)
-Allow access to camera and board inputs.
Slides in and out one direction. Usually print mine a brim just for adhesion, though not required.
Enjoy and comment about any issues/requests!
Creative Commons Attribution Noncommercial Share Alike