Little case for one Relais with Electronic Driver


Creative Commons Attribution Share Alike

Commercial use is allowed, you must attribute the creator, you may remix this work and the remixed work should be made available under this license.

Learn more or download attribution tags


Designing himself


I use this little Case for wallmount with a nail.
There is place in it for a Relais and it's electronic components and also a terminal strip and a fuse. At the upper side there are two holes for DC-Power and Trigger. At the downside there are two slots for small powercord, power inlet cable and output cable to lamp or other. At the front side there is a hole for a 5mm-LED. At the inner side there is up left and rught a holder for circuit board, in the middle a pin for fuseholder to put in the fuseholder and welding the pin withe iron to fix it, before there are four pieces and one pin in the middle to fix a terminal strip, left and right some leadthrough for fixing the power cord. I switch a lamp but also need for switch on the valve of my steam radiator.

Materials and methods

white PLA approximately 10meters
I need 10hours for printing, but I will look for faster print check up



Issues are used to track todos, bugs or requests. To get started, you could create an issue.


Mini il 570xn.1343682359 2jz9The 3D printing Guy commented ago

Thank you! Adds a lot of value to me.

Mini lichtbild neu 001Thomas Möhrling published this design ago