Thanks for downloading!
We'd love to hear from you if the print was successful.
Replacement Lowel 7038 Light Stand Set Knobs
Replace those little knobs that tend to back off the studs and get lost.
Other
Creative Commons Attribution Share Alike
Commercial use is allowed, you must attribute the creator, you may remix this work and the remixed work should be made available under this license.
Description
These are the SMALL set knobs for the Lowel Omni Stand 01-33 (and apparently Uni TO Stand UN-33 and Uni-stand UN-33), to replace the knob-end of Lowel part number 7038.
If you need the stud, it's kind of an odd bird. You can cut it from 12-24 all-thread, if such can be found. My studs are barely under 7/8in long in total (and they've apparently been ground at the end).
Materials and methods
I printed with PETG, 90% infill, .16mm layer, no support. Printed on the back - it's the biggest flat face.
The threaded holes have a couple of perpendicular crossing wells inside, so if you want to affix with epoxy, there's someplace for the epoxy to make a mechanical grab in there (epoxy will only make a mechanical, not a chemical bond with PETG and with the stud). Suggest you affix these with an adhesive - they tend to back off if not.
Be gentle: the screw thread follows the weak axis.
Edit in 3dslashIssues
Issues are used to track todos, bugs or requests. To get started, you could create an issue.
Comments
jddj published this design ago