Thanks for downloading!
We'd love to hear from you if the print was successful.
RigidBot Power Supply Upgrade
Part's I designed to upgrade my RigidBot's power supply to a MeanWell NES-350-24. I'm unsure if they'll work on other power supplies. I printed in ABS at 35% infill Video showing printing and installation. https://www.youtube.com/watch?v=9APKjs7_CEQ
3D printer parts and enhancements
Creative Commons Attribution Share Alike
Commercial use is allowed, you must attribute the creator, you may remix this work and the remixed work should be made available under this license.
Description
Materials and methods
-1x IEC switched C14 plug
-1x IEC C13 power cord.
-7x 4.8mm Non-insulated crimp terminals
-14ga hookup wire
-15A two-core power cable
-1x (Kycon/Mini-DIN) 4P power connector
-1x ferrite bead
-4x 15mm M4 Screws
-3x 10mm M4 Screws
-4x M4 Nuts
-2x 5mm M3 screws
-433mm 10mm OD Aluminium tube.
Documents
Edit in 3dslash
Issues
Issues are used to track todos, bugs or requests. To get started, you could create an issue.
Comments
Daniel Hould commented agoWas there a reason you made the flat section of the Case so thick? 4mm seems a bit excessive, but maybe you were concerned about rigidity. I just wanted to understand the theory behind it. Thanks.
Make'n'Mod published this design ago