Thanks for downloading!
We'd love to hear from you if the print was successful.
Runcam 5 Orange mount
Drone mount for the Runcam 5 Orange with sleeve and bases for the Pirx 7 and the TBS Source One frameOther
Creative Commons Attribution Share Alike
Commercial use is allowed, you must attribute the creator, you may remix this work and the remixed work should be made available under this license.
This set is comprised of a 3D-printed sleeve for the Runcam 5 Orange and an assortment of bases. Currently there are 20° mounting bases for the
- Pirx Seven (short and long version)
- TBS Source One
The bases can be fastened either with M3 bolts or using the small elongated holes on the bottom with wire straps. The base and sleeve feature slots for a velcro strap to keep everything in place. The sleeve features cutouts to keep access to all slots, ports, and buttons of the Runcam 5 available. You do not need to take the cam out of the sleeve or off your drone to charge it or transfer files via the USB cable.
Materials and methods
Print with TPU, 0.2 mm layer height, no supports are needed, except for the long version of the Pirx Seven base. The short Pirx base as well as the Source One base do not need supports.
Print the bases on the side, i.e. with the elongated holes for the velcro and wire straps facing the print plate. Print the sleeve with the front down towards the print plate with the open backside where the camera is inserted facing upwards.
I'd like to make a mount for a Tyro119. The frame is a bit long and I'm considering using PETG rather than TPU for the base. But my question is: Would you share the design files (STEP, etc.) for the base so I can make one for this drone? I will be happy to hare back anything I come up with. I use Fusion360 so pretty much any format is good.