×Read this message from Erik, founder of YouMagine

Issue The handle breaks #1

ThatJCB opened this issue on April 30, 2017 16:50

I use PLA to print all of my handles. The smaller handle breaks after a few uses. I suspect from hitting the lawn mower when it is let go.
I have made larger and stronger models and printed with 80% or 100% fill. The larger models survive.

I also added a thin resin coating to one and it has also survived but I think it would have done without the resin.

Use the largest latest version of the model for best results.

    Comments

    There are no comments yet.

    Back to Skull handle