Thanks for downloading!
We'd love to hear from you if the print was successful.
Soap Bubble Machine
This is a soap bubble machine which I built for the game "Bubble Blast"
Maker/DIY
Creative Commons Attribution
You can adapt, share or use this work commercially as long as you attribute the creator.
Description
This soap bubble machine is part of the open source game "Bubble Blast". You can find the BOM, a video and all additional information on my website: https://www.niklasroy.com/bubbleblast
Edit in 3dslashIssues
Issues are used to track todos, bugs or requests. To get started, you could create an issue.
Comments
royrobotiks commented agoI have a box with all kinds of motors and just took one out that was right for the purpose. I think I salvaged it from the lens system of an old video projector. So unfortunately I cannot help you with a good source. But you could also adapt the model to a motor that you have. However, if your motor is smaller, you could also print an adapter that makes the motor fit into the bubble machine.
jgbrown commented agoYep, confirmed they are all M3. Very nice fit. Likely a little inaccuracy in my printer made me question it. :-)
Would you happen to have a recommendation for the motor? There are all sorts of 12v, low RPM motors on eBay but must of them are a lot smaller than your suggested dimensions.
Thanks -- Jeff
royrobotiks commented agoIt's actually all M3 screws. If the holes are too small, you can use a 3mm drill to open them up a bit.
jgbrown commented agoWhat size hardware is used to connect everything? M3 seems to be too big. I don't have anything smaller so will need to order. Perhaps M2.5?
royrobotiks published this design ago