Spring-loaded Ultimaker short belt tensioner

Mooncactus design on thingiverse only had two holes for the stepper motor(should be four) but two screws on the lug side, over- constraining the screw. This design is intended to be mounted on the inside of your UM, between the casing and the motors. If you have and older type UM with t...

3D printer parts and enhancements

GPLv3

A free software license that requires that all work based on this must also be free software as in freely remixable and sharable by anyone under the same license but may be used commercially.

Learn more or download attribution tags

Description

Mooncactus design on thingiverse only had two holes for the stepper motor(should be four) but two screws on the lug side, over- constraining the screw. 

This design is intended to be mounted on the inside of your UM, between
the casing and the motors. If you have and older type UM with the stack
of plywood as spacers: you only need to remove one plate. If you have
the newer plastic spacers you probably need screws a little longer (2mm)
or you can get by with 2mm less thread in the motors?

Documents

Issues

Issues are used to track todos, bugs or requests. To get started, you could create an issue.

Comments

7e9cb5963e9dfc586503e3f915c46b1d?default=blank&size=40Jelle published this design ago