Thanks for downloading!
We'd love to hear from you if the print was successful. If you like the design, please consider donating to the designer.Donate to Engineering Nonsense
Sub $150 Drift Car V1 (Gearbox + Motor Mount)
Low budget drift car made using 3D printerMaker/DIY
Creative Commons Attribution Noncommercial Share Alike
Commercial use is not allowed, you must attribute the creator, you may remix this work and the remixed work should be made available under this license.
This is the Gearbox Assembly for my drift car.
BOM coming soon: (Incomplete attached file)
Hardware kit coming soon:
Links to other necessary printable components:
Main Chassis: https://www.thingiverse.com/thing:2975634
Front Assembly: https://www.thingiverse.com/thing:2975781
Rear assembly: https://www.thingiverse.com/thing:2975663
Drive Assembly: (YOU ARE HERE)
Materials and methods
Print with PLA at the highest temp you can. Preferably 210 degrees C.
No support needed if you use the right orientation to print each part.
Issues are used to track todos, bugs or requests. To get started, you could create an issue.