Thanks for downloading!
We'd love to hear from you if the print was successful.
Table support for headset
Headphones table holderFor your home
Creative Commons Attribution Share Alike
Commercial use is allowed, you must attribute the creator, you may remix this work and the remixed work should be made available under this license.
Hold headphones and its wire to the border or the table.
Tested in PLA in 0.2mm layer:
- No small details so a 0.2mm layer high is ok (0.4 mm hotend)
- Since PLA is not very strong it is recommended >=25% infill that way the piece won't suffer if the screw is tight.
- No support needed
- I additionally used just a bit of "Pritt Multi Tack" to ensure the piece won't move because my table is quiet slippery (even though the screw is tight enough)
Issues are used to track todos, bugs or requests. To get started, you could create an issue.