Taller eyecups for SZM7045 trinocular microscope

Creative Commons Attribution Share Alike

Commercial use is allowed, you must attribute the creator, you may remix this work and the remixed work should be made available under this license.

If original rubber eyecups don't work for you,
because your eyes get too close to the oculars,
you might want to try this design, which is taller.

The eyecups fit tightly and clip on to oculars, when pushed all the way onto them.

Your support kindly accepted here: https://paypal.me/ZigaM3.

Filament: black PLA.

To avoid printing supports, cut the object into two,
print the bottom part flipped upside down,
and then glue them together with superglue.

Issues are used to track todos, bugs or requests. To get started, you could create an issue.

ZigaM published this design over 3 years ago