Thanks for downloading!
We'd love to hear from you if the print was successful.
I scuplted this Tiki guy for practice using 3dCoat.For your home
Creative Commons Attribution Share Alike
Commercial use is allowed, you must attribute the creator, you may remix this work and the remixed work should be made available under this license.
I made this Tiki to practice sculpting in 3dCoat.
To print hollow (as shown):Print with no infill and no top shells.
To finish: spray with red primer. Palint over with black paint then rub off while still wet leaving the black only in the cracks and crevices.
We talked about this thing and a whole lot more about 3d printing on the 3D Printing Today podcast available on iTunes, Stitcher radio or direct from the source at http://threedprintingtoday.libsyn.com/
Materials and methods
-red rustoleum primer
-black acrylic paint
Issues are used to track todos, bugs or requests. To get started, you could create an issue.