<p>I made this Tiki to practice sculpting in 3dCoat. </p><p><b>To print hollow (as shown):</b>Print with no infill and no top shells.</p><p><b>To finish:</b> spray with red primer. Palint over with black paint then rub off while still wet leaving the black only in the cracks and crevices.</p><p>We talked about this thing and a whole lot more about 3d printing on the <strong>3D Printing Today podcast</strong> available on iTunes, Stitcher radio or direct from the source at <a target="_blank" rel="nofollow" href="http://threedprintingtoday.libsyn.com/">http://threedprintingtoday.libsyn.com/</a></p>
Creative Commons Attribution Share Alike
