My wife wanted to have a towel rack in the sauna. No need to say that it should have a sufficiently high WAF ("wife acceptance factor").<br><br>For temperatures common in a sauna, up to 90°C, ABS is the material of choice. The STL with suffix <i>_ABS</i> has an additional strong brim, in case you have adhesion problems.<br><br>If using counter sunk screws, see the drawing attached! Pressure must build against the stick, not the printed part, or the <b>part will be split</b> by the forces. Put the mounts on the stick leveled, drill through the holes from the flat side, all through the stick. Then turn and drill a wider hole in the stick for the screw head, from the front side, at about half the stick diameter deep. <br><br>Flat heads, maybe with washers, may work, but are not tested.
Creative Commons Attribution Noncommercial Share Alike