Tower Header (50mm Pipe) for the MKII Wind Turbine

A custom tower header for the MKII Wind Turbine

Commercial use is allowed, you must attribute the creator, you may remix this work and the remixed work should be made available under this license.

Based on original design: MKII 5 Watt 3d printable Wind Turbine by Daniel Davis

8190

This is a custom tower header for a 50mm pipe.
It contains for parts:

The tower header for a 50mm pipe
A stress relief for 2.5 mm turning part of the slipring
A stress relief for the power cable inside the pipe. Place this inside the tower header
A rain cover

Use some wire to connect both stress reliefs.

Issues are used to track todos, bugs or requests. To get started, you could create an issue.

Zooloco added this to the Mills collection about 5 years ago

Daniel Davis added this to the Wind Turbine Contributions collection over 6 years ago

Sepio published this design almost 7 years ago