<p>Articulated hands for Combiner wars style Gestalts and any other that attach on a 5mm peg. not suitable for holding 5mm peg guns. </p><p>note - printed on my ultimaker original plus, this design requires some fine tuning like re-drilling the holes for the steel rod, cutting the rod in pieces, there might be some friction issues that will require sanding/filing. </p><p><br></p><p>You need to mirror the hand body in your slicer to get the other hand done ;) </p><p><br></p><p>the hinges for all fingers are universal, so you will need 5 per hand</p><p>middlefinger section is also universal, you need 5 per hand </p><p>fingertips - 1 short for thumb, 2 long for middle and 2 regular for sides </p><p>1 peg per hand </p><p>if you need to have the holes re-drilled i recommend a hand drill of 1mm, anything faster than very slow will cut through like butter (temperature) </p><p>i get best results with PLA, on UMO+ with this setup </p><p>temp: 215 c</p><p>bed: 50 c </p><p>layer hight: 0.1 </p><p>shell: 0.8</p><p>bottom/top fill: 0.8</p><p>infill: 100%</p><p>print speed: 30mm/s (speed applied to ALL categories of printing/travel eg. infill, shell, top, bottom)</p><p>support type: everywhere for hand body only, none for fingers and hinges</p><p>platform adhension: brim - 20 lines</p><p>PRINT ONE AT A TIME - enabled, otherwise you will get horrible stringing </p><p><br></p><p>this is still tested and developed, feel free to leave comments and tips. if needed i can share alibre source files. </p>
the project is free but it would be nice if you gave some appreciation and contributed so i can keep wasting my time on doing cool stuff like that ;) if you want to contribute please pm me or go to paypal.me/PiotrSidoruk
thanks and enjoy!
Creative Commons Attribution Share Alike
