<p>I replaced the black plastic mesh and black shrink tubing around the cables going to my Ultimaker 2 hot end gantry with white versions of both. Now that I had all that white goodness, those original black bowden-to-mesh-cable clips were an eye sore! Measured one, modeled it in Sketchup and it came out perfect! Now you can have any color/material you like for your clips.</p><p>I printed mine with Faberdashery's Architect's Stone. The color blends nicely with the slightly different shades of white of the other materials. Love the color of that filament! I should have taken a close up photo of a print that came out much nicer. The first image above is flipped upside down and wow!, my first layer was pretty under-extruded!</p><p>Anyway, the two open circles 'snap' onto the bowden tube just as tightly as the original. I'm very happy with my first YouMagine contribution :)</p><p><b>Update:</b> Having an enclosed print area is bad for PLA parts. The ambient temps when printing ABS is too high and the clips all melted. I have since reprinted them in ABS and everything is fine.</p>
Creative Commons Attribution Share Alike