<p>I used 3x25mm screws to fix.<br>This fixes the Ultimaker 2 in place. </p><p>I have a little space to the back for two reasons:</p><p>1. My office is under the roof so I have angled walls and when I place my Ultimaker 2 to the very edge of the shelf the bowden tube hits the wall, the space is enough so it only slightly touches the wall.</p>2. The power cord and the USB cable have a little more rest on the shelf and are not bent right after leaving the case.<div><strong><br></strong></div><div><strong>For real fixing both parts are needed, one on each side! That is why there is a normal and a mirrored part. Otherwise the printer can turn and crack the part or slide to the side!</strong></div><div><br></div><div>For mounting place the parts on the shelf, place the Ultimaker 2 in the parts then slide the parts to the outside as far as possible. Then screw them in place.<p>The printer can be easily removed by lifting it out of the parts.</p><p>Printed parts oriented as shown in the renders.<br>Need supports in the upper area.<br></p></div>
Creative Commons Attribution Noncommercial Share Alike
