Ultimaker 3 Print Core Rack

Storage for three print cores, mounts with an original screw on the side panel!

3D printer parts and enhancements

    Creative Commons Attribution Share Alike

    Commercial use is allowed, you must attribute the creator, you may remix this work and the remixed work should be made available under this license.

    Learn more or download attribution tags

    Attribution

    Based on original design: Ultimaker 3 Print Core Rack by Erik Cederberg

    Description

    Print on it's back. Simply remove one of the top screws on either side panel to mount.

    I derived this from Erik's wonderful design, but I only have three print cores total so six slots was more than I needed. I simply edited the STL by "cutting" the extra slots off and adding the counterbored hole in the middle.

    Materials and methods

    I used PLA and 0.1mm layer heights for a nice looking print.

    Documents

    Issues

    Issues are used to track todos, bugs or requests. To get started, you could create an issue.

    Comments

    C6f0193c25723df61ce85f3d894b5300?default=blank&size=40David F. published this design ago