Ultimaker bowden clamp v3

Evolution of Bowden Clamp for Ultimaker Hot end v2, original design by Owen.

Commercial use is allowed, you must attribute the creator, you may remix this work and the remixed work should be made available under this license.

Source on Github : https://github.com/hugokernel/OpenSCAD_Things/tree/master/Bowden%20Clamp%20v3

4 12mm washer is required to distribute the clamping force from the bolts.
4 slots are provided below to place the nuts to hold the 2 electronic board.

Instructions :
- Get pneumatic push-fit like this one http://www.ebay.com/itm/LOT5-One-Touch-Hex-Socket-Male-Connector-6mm-1-8-thread-Replace-SMC-KQ2S06-0... (you need to drill the bottom part)
- Print support.stl

More information in french here : http://bit.ly/1aY8ZWj

Issues are used to track todos, bugs or requests. To get started, you could create an issue.

tuttoflash added this to the Ultimaker collection about 5 years ago

kesjeff added this to the Ultimaker collection over 7 years ago

samantha botha added this to the usefull collection over 7 years ago

hugokernel published this design about 10 years ago