Thanks for downloading!
We'd love to hear from you if the print was successful.
Ultimaker original plus direct drive filament holder
Filament holder to fit on any side of the ultimaker
3D printer parts and enhancements
Creative Commons Attribution Share Alike
Commercial use is allowed, you must attribute the creator, you may remix this work and the remixed work should be made available under this license.
Description
After changing UM to direct drive, new spool holder is required to reduce the stress on the head.
This spool holder can be placed on any side of the UM + (and other Ultimaker printers with same wall width). It is simply snapped into place and can be simply removed, but provides enough support for any type of filament.
Two corks are needed and they are pushed into the tube on each end as far as possible (for few mm to remain). The tube with corks snaps into the left and right leg and then the whole thing snaps on the UM.
When changing filament, remove one of the legs, swap the spool and snap the leg back on
Materials and methods
PLA
2mm layers
20% infil
Cork.stl x 2
Documents
Issues
Issues are used to track todos, bugs or requests. To get started, you could create an issue.