Issue PLA not right for Cable Chain #1

CS opened this issue on October 23, 2018 17:50

This cable chain was the first thing I printed when I bought my Ultimaker. I just noticed it had degraded and reprinted a new Bed End. The original was made from PLA and that's the reason I need to replace it. Specifically, heat from the metal plate the Bed End is screwed to, has, over time deformed the PLA and now I can't remove the screws that hold it in place without some delicate cutting. The Bed End must be printed with greater heat resistance than PLA can deliver. Trust me on this.

Comments

There are no comments yet.

You need to log in to create a new comment.

Back to Ultimaker2 Cable Chain